speedway series 125 amp flux welder manual

Contact Tipįinally, be sure that your contact tip ID matches the wire size and that its hole is still round. We recommend changing your liner once a year to avoid the build-up of debris and keep everything running smoothly. Make sure you’re using the right MIG liner size for your wire, and choose a high-quality liner that maintains a consistent diameter throughout.Īs always, regular maintenance can extend the life of your liner, eliminate wire-feed problems and ward off the downtime that comes with replacing it. If you suspect a clog, try blowing it out with low-pressure compressed air. And while it might be inexpensive to replace a bad liner, it’s also one of the more time-consuming consumables to change out. Inspect Gun Linerīecause of its lengthy contact with the wire, a dirty, kinked, clogged, or otherwise damaged liner will almost always cause feeding problems. The groove size should match the wire: V-grooved rolls for solid wire, U-grooved rolls for soft metals such as aluminum, and V-knurled rolls for flux-core. If either is incorrect, it can lead to slippage.

In addition, check that you’re using the right type and size of drive rolls for your wire.

When parameters are correct, it may just be time to change your drive rolls.

If all looks well, make sure the feed settings are still set properly and the wire is within spec.

If you notice you’re having to tighten your drive rolls more than before, check for damage or wear.

Continue to increase the tension until you’re one-half turn past wire slippage.

Loosen the drive rolls, then increase the tension while feeding the wire into a block of wood or metal.

It’s not an exact science, but here are some pro tips to help you get close: Too much tension can cause wear on the wire and too little can lead to birdnesting, so it’s important to find the sweet spot on both parts. Your welding wire not feeding properly off the spool is likely due to incorrect tension on either the spool break, the drive rolls, or both. Once you’re in the habit, it will save you time and money in the long run. Maintaining your wire in between jobs is as easy as taking it out of the welder and putting it under a blanket or in a garbage bag. You’ll also need to either blow out or replace your liner (more on that later.) Any wire deformity can also cause issues in feeding. If you do see rust, you can try and unspool until you find clean wire.

Moisture or disuse for long periods of time can cause rust, which in turn will clog up your liner. And because wire-feed issues can happen anywhere along the length of the gun, you may need to check several areas until you find the problem.įirst, take a look at the wire itself.

Trouble with your MIG wire not feeding properly can lead to various frustrating problems that lead to downtime, extra cost, and all the associated headaches that come with having to stop what you’re doing and troubleshoot.

Speedway series 125 amp flux welder manual